MTS Series 793 - Manual (Page 123)

specific groups of tests. This allows you to run different types of tests using the same station configuration
file.
Parameter set management
When you open a station configuration, you can select the appropriate parameter set needed to run the test.
Once a station configuration is loaded, you can load a different parameter set.
Parameter settings
Most of the settings stored in a parameter set are accessed through the Station Setup window. All of the
Station Manager application settings can be saved to a station parameter set that is associated with the
current station configuration file. If you change parameter settings, you are prompted to save the changes to
the parameter set when you close the station.
About Parameter Settings
Most of the settings stored in a parameter set are accessed through the Station Setup window. Parameter
settings include:
• System calibration and tuning settings
• Limit and error detector settings
• User-defined calculated signal settings
• Signal compensation and stabilization settings
• Views (window locations, scope, and meters)
• Any changes to Unit Assignment settings
• Manual command slider settings
• Setpoint slider settings
How to Determine What Parameter Set Is Being Used
The Station Manager window title bar displays both the station configuration and parameter set being used.
How to Save and Manage Parameter Sets
The following File menu selections are used to manage the parameter sets associated with the currently
loaded station configuration.
MTS Series 793 Control Software 123
Station Manager Application