Lenze DSD - Manual (Page 447)

Lenze · Drive Solution Designer · Manual · DMS 4.2 EN · 12/2013 · TD23
447
18 Drive dimensioning messages
18.2 Drive system
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
18.2.8 Torque setting range yyy requires measures
18.2.9 Torque setting range yyy and tensile force setting range zzz require measures
Note!
For the selected winding control mode xxx and the torque setting range yyy, we recommend low-friction,
mechanical transmission elements between the motor and the winding shaft as well as a KTY sensor for
the compensation of the motor temperature.
Cause Effects Possible remedies
The torque setting range results from
the entered values for tensile force
and diameter.
Minimum tensile forces cannot be re-
alised without the recommended
measures.
• Carry out recommended meas-
ures.
Note!
For the selected winding control mode xxx, the torque setting range yyy and the tensile force setting range
zzz, we recommend low-friction, mechanical transmission elements between the motor and the winding
shaft as well as a KTY sensor for the compensation of the motor temperature.
Cause Effects Possible remedies
The torque setting range results from
the entered values for tensile force
and diameter.
Minimum tensile forces cannot be re-
alised without the recommended
measures.
• Carry out recommended meas-
ures.