9 calling line identification restriction - +clir – Rainbow Electronics GM862-QUAD-PY User Manual

Page 95

AT Commands Reference Guide

80000ST10025a Rev. 5 - 09/07/08

page 95 of 434

3.5.4.3.9 Calling Line Identification Restriction - +CLIR

+CLIR - Calling Line Identification Restriction

SELINT 0 / 1

AT+CLIR[=[]]

Set command overrides the CLIR subscription when temporary mode is
provisioned as a default adjustment for all following outgoing calls. This
adjustment can be revoked by using the opposite command.
This command refers to CLIR-service (GSM 02.81) that allows a calling
subscriber to enable or disable the presentation of the CLI to the called
party when originating a call.

Parameter:
- facility status on the Mobile
0 - CLIR facility according to CLIR service network status
1 - CLIR facility active (CLI not sent)
2 - CLIR facility not active (CLI sent)

Note: issuing AT+CLIR is the same as issuing the Read command.

Note: issuing AT+CLIR= is the same as issuing the command
AT+CLIR=0.

AT+CLIR?

Read command gives the default adjustment for all outgoing calls () and
also triggers an interrogation of the provision status of the CLIR service
(), where

- facility status on the Mobile
0 - CLIR facility according to CLIR service network status
1 - CLIR facility active (CLI not sent)

2 - CLIR facility not active (CLI sent)

- facility status on the Network
0 - CLIR service not provisioned
1 - CLIR service provisioned permanently
2 - unknown (e.g. no network present, etc.)
3 - CLI temporary mode presentation restricted
4 - CLI temporary mode presentation allowed

AT+CLIR=?

Test command reports the supported values of parameter .

Reference GSM

07.07

Note

This command sets the default behaviour of the device in outgoing calls.

+CLIR - Calling Line Identification Restriction

SELINT 2

AT+CLIR=[]