Rainbow Electronics GM862-QUAD-PY - Manual (Page 380)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 380 of 434
#CSURV - Network Survey SELINT 2
(The following informations will be printed only if GPRS is supported in the
cell)
> - packet broadcast control channel
0 - pbcch not activated on the cell
1 - pbcch activated on the cell
> - network operation mode
1
2
3
> - routing area code
0..255 -
> - SPLIT_PG_CYCLE support
..0 - SPLIT_PG_CYCLE is not supported on CCCH on this cell
..1 - SPLIT_PG_CYCLE is supported on CCCH on this cell
- priority access threshold
0 -
3..6 -
- network control order
0..2 -
- timer 3168
- timer 3192
- discontinuous reception max time (in seconds)
- packed control ack
- blocked sequenc countdown max value
- alpha parameter for power control
- type of channel which shall be used for downlink
measurements for power control
0 - BCCH
1 - PDCH
(For non BCCH-Carrier)
arfcn: rxLev:
where:
- decimal number; it is the RF channel
- decimal number; it is the receiption level (in dBm)
Lastly, the #CSURV output ends in two ways, depending on the last
#CSURVF setting:
if #CSURVF=0 or #CSURVF=1
The output ends with the string:
Network survey ended