Rainbow Electronics GM862-QUAD-PY - Manual (Page 124)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 124 of 434
+CMER - Mobile Equipment Event Reporting SELINT 2
(after +++ was entered), all URCs stored in the buffer will be output.
- keypad event reporting
0 - no keypad event reporting
- display event reporting
0 - no display event reporting
- indicator event reporting
0 - no indicator event reporting
2 - indicator event reporting
- TA buffer clearing
0 - TA buffer of unsolicited result codes is cleared when 1..3 is
entered
AT+CMER? Read command returns the current setting of parameters, in the format:
+CMER: ,,,,
AT+CMER=? Test command returns the range of supported values for parameters
, , , , , in the format:
+CMER: (list of supported s),(list of supported s),
(list of supported s),(list of supported s),(list of supported
s)
Reference GSM 07.07
3.5.4.4.7 Select Phonebook Memory Storage - +CPBS
+CPBS - Select Phonebook Memory Storage SELINT 0 / 1
AT+CPBS[=
] Set command selects phonebook memory storage , which will be
used by other phonebook commands.
Parameter:
"SM" - SIM phonebook
"FD" - SIM fixed dialling-phonebook (only phase 2/2+ SIM)
"LD" - SIM last-dialling-phonebook (+CPBF is not applicable for this
storage)
"MC" - device missed (unanswered received) calls list (+CPBF is not
applicable for this storage)
"RC" - ME received calls list (+CPBF is not applicable for this storage)
Note: If parameter is omitted then Set command has the same behaviour as
Read command.
AT+CPBS? Read command returns the actual values of the parameter , the
number of occupied records and the maximum index number
, in the format:
+CPBS: ,,
Note: For =”MC”: if there are more than one missed calls from