Rainbow Electronics GM862-QUAD-PY - Manual (Page 54)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 54 of 434
D – Dial SELINT 2
&Z)
ATDI[;]
ATDi[;] Issues a call overwriting the CLIR supplementary service subscription
default value for this call
If “;” is present a voice call is performed.
I - invocation, restrict CLI presentation
i - suppression, allow CLI presentation
ATDG[;]
ATDg[;] Issues a call checking the CUG supplementary service information for the
current call. Refer to +CCUG command.
If “;” is present a voice call is performed.
ATD*
[*][*[]
[*[]]]]# This command is specific of GPRS functionality and causes the MT to
perform whatever actions are necessary to establish communication
between the TE and the external PDN.
Parameters:
- GPRS Service Code, a digit string (value 99) which identifies
a request to use the GPRS
- string that identifies the called party in the address space
applicable to the PDP.
- a string which indicates the layer 2 protocol to be used (see
+CGDATA command). For communications software that
does not support arbitrary characters in the dial string, the
following numeric equivalents shall be used:
1 - PPP
- a digit which specifies a particular PDP context definition (see
+CGDCONT command).
Example To dial a number in SIM phonebook entry 6:
ATD>SM6
OK
To have a voice call to the 6-th entry of active
phonebook:
ATD>6;
OK
To call the entry with alphanumeric field “Name”:
ATD>”Name”;
OK
Reference V25ter.
3.5.3.3.2 Tone Dial - T
T - Tone Dial SELINT 0 / 1 / 2
ATT Set command has no effect is included only for backward compatibility with
landline modems.
Reference V25ter.