Rainbow Electronics GM862-QUAD-PY - Manual (Page 405)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 405 of 434
#STSR - SIM Tookit Send Response SELINT 2
[,]] Parameters:
- integer type; proactive command ID according to GSM
11.14 (see #STGI)
- action performed by the user
0 - command performed successfully (call accepted in case of call setup)
16 - proactive SIM session terminated by user
17 - backward move in the proactive SIM session requested by the user
18 - no response from user
19 - help information required by the user
20 - USSD/SS Transaction terminated by user
32 - TA currently unable to process command
34 - user has denied SIM call setup request
35 - user cleared down SIM call before connection or network release
- data entered by user, depending on , only required if
is 0:
Get Inkey
contains the key pressed by the user; used character set should be
the one selected with +CSCS.
Note: if, as a user response, a binary choice (Yes/No) is requested by the
SIM application using bit 3 of the parameter the valid
content of the is:
a) “IRA”, ”8859-1”, ”PCCP437” charsets: “Y” or “y” (positive answer) and “N”
or “n” (negative answer)
b) UCS2 alphabet “0079” or “0059” (positive answer) and “006E” or “004E”
(negative answer)
Get Input
- contains the string of characters entered by the user (see above)
Select Item
- contains the item identifier selected by the user
Note:
Use of icons is not supported. All icon related actions will respond with no
icon available.
AT#STSR? The read command can be used to request the currently ongoing proactive
command and the SAT state in the format
#STSRI: ,
where:
- SAT interface state (see #STIA)
- ongoing proactive command
An error message will be returned if there is no pending command.
AT#STSR=? Test command returns the range for the parameters and