46 query sim status - #qss – Rainbow Electronics GM862-QUAD-PY User Manual

Page 280

AT Commands Reference Guide

80000ST10025a Rev. 5 - 09/07/08

page 280 of 434

#COPSMODE - +COPS Mode

SELINT 0 / 1

1 - +COPS behaviour compliant with ETSI format

Note: The setting is saved in NVM (and available on following reboot).

Note: if parameter is omitted the behaviour of Set command is
the same as Read command.

AT#COPSMODE?

Read command returns the current behaviour of +COPS command, in the
format:

#COPSMODE:

where
- +COPS behaviour as seen before.

AT#COPSMODE=?

Test command returns the range of available values for parameter
.

Note

It’s suggested to reboot the module after every #COPSMODE setting.

3.5.7.1.46 Query SIM Status - #QSS

#QSS - Query SIM Status

SELINT 0 / 1

AT#QSS[=
[]]

Set command enables/disables the Query SIM Status unsolicited indication
in the ME.

Parameter:
- type of notification
0 - disabled (factory default); it’s possible only to query the current SIM

status through Read command AT#QSS?

1 - enabled; the ME informs at every SIM status change through the

following unsolicited indication:

#QSS:

where:
- current SIM status
0 - SIM NOT INSERTED
1 - SIM INSERTED

Note: issuing AT#QSS is the same as issuing the Read command.

AT#QSS?

Read command reports whether the unsolicited indication #QSS is currently
enabled or not, along with the SIM status, in the format:

#QSS: ,
( and are described above)

AT#QSS=?

Test command returns the supported range of values for parameter
.