Rainbow Electronics GM862-QUAD-PY - Manual (Page 365)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 365 of 434
#EADDR - E-mail Sender Address SELINT 0 / 1
#EADDR:
AT#EADDR=? Test command returns the maximum allowed length of the string parameter
.
Example AT#EADDR="[email protected]"
OK
AT#EADDR?
#EADDR: "[email protected]"
OK
#EADDR - E-mail Sender Address
SELINT 2
AT#EADDR=
[] Set command sets the sender address string to be used for sending the e-
mail.
Parameter:
- sender address, string type.
- any string value up to max length reported in the Test command.
(factory default is the empty string “”)
AT#EADDR? Read command reports the current sender address, in the format:
#EADDR:
AT#EADDR=? Test command returns the maximum allowed length of the string parameter
.
Example AT#EADDR="[email protected]"
OK
AT#EADDR?
#EADDR: "[email protected]"
OK
3.5.7.6.3 E-mail Authentication User Name - #EUSER
#EUSER - E-mail Authentication User Name SELINT 0 / 1
AT#EUSER
[=] Set command sets the user identification string to be used during the
authentication step of the SMTP.
Parameter:
- e-mail authentication User ID, string type.
- any string value up to max length reported in the Test command.
(factory default is the empty string “”)
Note: if no authentication is required then the parameter shall be
empty "".
Note: If parameter is omitted then the behaviour of Set command is the
same of Read command
AT#EUSER? Read command reports the current user identification string, in the format: