Rainbow Electronics GM862-QUAD-PY - Manual (Page 314)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 314 of 434
the dynamic address assigned during the GSM context
activation.
b) if is a PDP context identifier ( in (1..5)) it is a
string that identifies the terminal in the address space
applicable to the PDP. The address may be static or
dynamic. For a static address, it will be the one set by the
+CGDCONT command when the context was defined. For
a dynamic address it will be the one assigned during the
last PDP context activation that used the context definition
referred to by .
Note: if no address is available the empty string (“”) is represented as
AT#CGPADDR=? Test command returns a list of defined s.
Example AT#SGACT=0,1
+IP: xxx.yyy.zzz.www
OK
AT#CGPADDR=0
+CGPADDR: 0,”xxx.yyy.zzz.www”
OK
AT#CGPADDR=?
+CGPADDR: (0)
OK
3.5.7.1.89 Network Scan Timer - #NWSCANTMR
#NWSCANTMR - Network Scan Timer SELINT 2
AT#NWSCANTMR=
Set command sets the Network Scan Timer that is used by the module to
schedule the next network search when it is without network coverage (no
signal).
Parameter:
- timer value in units of seconds
5 3600 - time in seconds (default 5 secs.)
AT#NWSCANTMR Execution command reports time, in seconds, when the next scan activity
will be executed. The format is:
#NWSCANTMREXP:
Note: if is zero it means that the timer is not running
AT#NWSCANTMR? Read command reports the current parameter setting for #NWSCANTMR
command in the format: