Rainbow Electronics GM862-QUAD-PY - Manual (Page 135)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 135 of 434
+CALA - Alarm Management SELINT 0 / 1
Note: if no alarm is present a is issued.
AT+CALA=? Test command returns the list of supported index values (currently just 0),
alarm types and maximum length of the text to be displayed, in the format:
+CALA: (list of supported s),(list of supported s),
where:
and as before
- maximum field length, integer type
Note: an enhanced version of Test command has been defined,
AT+CALA=??, providing the range of available values for and
too.
AT+CALA=?? Test command returns the list of supported index values (currently just 0),
alarm types, maximum length of the text to be displayed, maximum length
of and supported s, in the format:
+CALA: (list of supported s),(list of supported s),,
,(list of supported s)
where:
, , and as before
- maximum field length, integer type
Example AT+CALA="02/09/07,23:30:00+00"
OK
Reference ETSI 07.07, ETSI 27.007
+CALA - Alarm Management
SELINT 2
AT+CALA=
[,[,
[,[,
[,]]]]] Set command stores in the internal Real Time Clock an alarm time with
respective settings. It is possible to set up a recurrent alarm for one or more
days in the week.
Currently just one alarm can be set.
When the RTC time reaches the alarm time then the alarm starts, the
behaviour of the MODULE depends upon the setting and if the
device was already ON at the moment when the alarm time had come.
Parameters:
- current alarm time as quoted string
“” - (empty string) deletes the current alarm and resets all the +CALA
parameters to the “factory default” configuration
"hh:mm:ss±zz" - format to be used only when issuing +CALA with
parameter too.
"yy/MM/dd,hh:mm:ss±zz" - generic format: it’s the same as defined for
+CCLK (see)
- index of the alarm