Rainbow Electronics GM862-QUAD-PY - Manual (Page 367)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 367 of 434
#EPASSW - E-mail Authentication Password SELINT 0 / 1
(factory default is the empty string “”)
Note: if no authentication is required then the parameter shall be
empty "".
AT#EPASSW=? Test command returns the maximum allowed length of the string parameter
.
Example AT#USERID="myPassword"
OK
Note It is a different password field than the one used for GPRS authentication
(see #PASSW).
#EPASSW - E-mail Authentication Password
SELINT 2
AT#EPASSW=
[] Set command sets the password string to be used during the authentication
step of the SMTP.
Parameter:
- e-mail authentication password, string type.
- any string value up to max length reported in the Test command.
(factory default is the empty string “”)
Note: if no authentication is required then the parameter shall be
empty "".
AT#EPASSW=? Test command returns the maximum allowed length of the string parameter
.
Example AT#EPASSW="myPassword"
OK
Note It is a different password field than the one used for GPRS authentication
(see #PASSW).
3.5.7.6.5 E-mail Sending With GPRS Context Activation - #SEMAIL
#SEMAIL - E-mail Sending With GPRS Context Activation SELINT 0 / 1
AT#SEMAIL=,
,
[,] Execution command activates a GPRS context, if not previously activated
by #EMAILACT, and sends an e-mail message. The GPRS context is
deactivated when the e-mail is sent.
Parameters:
- destination address, string type.
- subject of the message, string type.
- attached image flag; if is present and not empty,
is assumed to be always 1, no matter what value it really is.
0 - don't attach any image
1 - attach the last snapshot taken
- attached image file name on remote party (default is
“snapshot.jpg”)