11 socket tcp connection time-out - #sktct – Rainbow Electronics GM862-QUAD-PY User Manual
Page 344
AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 344 of 434
3.5.7.5.11 Socket TCP Connection Time-Out - #SKTCT
#SKTCT - Socket TCP Connection Time-Out
SELINT 0 / 1
AT#SKTCT[=
Set command sets the TCP connection time-out for the first CONNECT
answer from the TCP peer to be received.
Parameter:
10..1200 - hundreds of ms (factory default value is 600).
Note: this time-out applies only to the time that the TCP stack waits for the
CONNECT answer to its connection request.
Note: The time for activate the GPRS and resolving the name with the DNS
query (if the peer was specified by name and not by address) is not counted
in this time-out.
Note: if parameter is omitted then the behaviour of Set command is the
same as Read command.
AT#SKTCT?
Read command reports the current TCP connection time-out.
AT#SKTCT=?
Test command returns the allowed values for parameter
Example
AT#SKTCT=600
OK
socket first connection answer time-out has been set to
60 s.
#SKTCT - Socket TCP Connection Time-Out
SELINT 2
AT#SKTCT=
[
Set command sets the TCP connection time-out for the first CONNECT
answer from the TCP peer to be received.
Parameter:
10..1200 - hundreds of ms (factory default value is 600).
Note: this time-out applies only to the time that the TCP stack waits for the
CONNECT answer to its connection request.
Note: The time for activate the GPRS and resolving the name with the DNS
query (if the peer was specified by name and not by address) is not counted
in this time-out.
Note: this command is not allowed for sockets associated to a GSM context
(see #SCFG).
AT#SKTCT?
Read command reports the current TCP connection time-out.
AT#SKTCT=?
Test command returns the allowed values for parameter
Example
AT#SKTCT=600
OK
socket first connection answer time-out has been set to
60 s.