Rainbow Electronics GM862-QUAD-PY - Manual (Page 35)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 35 of 434
+FCLASS - Select Active Service Class SELINT 0 / 1 / 2
0 - data
1 - fax class 1
8 - voice
AT+FCLASS? Read command returns the current configuration value of the parameter
.
AT+FCLASS=? Test command returns all supported values of the parameters .
Reference GSM 07.07
3.5.3.1.4 Default Reset Basic Profile Designation - &Y
&Y - Default Reset Basic Profile Designation SELINT 0 / 1 / 2
AT&Y[] Execution command defines the basic profiles which will be loaded on
startup.
Parameter:
0..1 - profile (default is 0): the wireless module is able to store 2 complete
configurations (see &W).
Note: differently from command Z, which loads just once the desired
profile, the one chosen through command &Y will be loaded on every
startup.
Note: if parameter is omitted, the command has the same behaviour as
AT&Y0
3.5.3.1.5 Default Reset Full Profile Designation - &P
&P - Default Reset Full Profile Designation SELINT 0 / 1 / 2
AT&P[] Execution command defines which full profile will be loaded on startup.
Parameter:
0..1 – profile number: the wireless module is able to store 2 full
configurations (see command &W).
Note: differently from command Z, which loads just once the desired
profile, the one chosen through command &P will be loaded on every
startup.
Note: if parameter is omitted, the command has the same behaviour as
AT&P0
Reference Telit Specifications