Rainbow Electronics GM862-QUAD-PY User Manual
Page 370
AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 370 of 434
#EMAILACT - E-mail GPRS Context Ativation
SELINT 0 / 1
0 - GPRS context deactivated
1 - GPRS context activated
Note: issuing AT#EMAILACT=
AT#EMAILACT=0
Note: if you request a GPRS context deactivation during a call issuing either
AT#GPRS=0 or AT#EMAILACT=0 and then, after the call termination, you
want to request a GPRS context activation through #EMAILACT, you need
to issue the following sequence of three commands
AT#EMAILACT=1
OK
AT#EMAILACT=0
OK
AT#EMAILACT=1
OK
AT#EMAILACT?
Read command has the same effect of the Execution command
AT#EMAILACT
AT#EMAILACT=?
Test command returns the allowed values for parameter
Example
AT#EMAILACT=1
OK
Now GPRS Context has been activated
AT# EMAILACT=0
OK
Now GPRS context has been deactivated.
Note
It is strongly recommended to use the same command (e.g. #EMAILACT)
to activate the context, deactivate it and interrogate about its status.
#EMAILACT - E-mail GPRS Context Ativation
SELINT 2
AT#EMAILACT=
[
Execution command deactivates/activates the PDP context #1, eventually
proceeding with the authentication with the parameters given with #PASSW
and #USERID.
Parameter:
0 - GPRS context deactivation request
1 - GPRS context activation request
Note: at least a socket identifier needs to be associated with PDP context
#1 in order to every #EMAILACT action be effective; by default the PDP
context #1 is associated with socket identifiers 1, 2 and 3, but it is
possible to modify these associations through #SCFG. Trying to issue a
#EMAILACT action when no socket identifier is associated with PDP