Rainbow Electronics GM862-QUAD-PY User Manual

Page 214

AT Commands Reference Guide

80000ST10025a Rev. 5 - 09/07/08

page 214 of 434

@CMGR - Read Message Improved

SELINT 1

Output format for received messages:

@CMGR: ,,, [,,,,,,
,]

Output format for either sent or unsent messages:
@CMGR: ,[,,,,,,,
,,]

Output format for message delivery confirm:
@CMGR: ,,,,,,

,

where:
- status of the message
"REC UNREAD" - new received message unread
"REC READ" - received message read
"STO UNSENT" - message stored not yet sent
"STO SENT" - message stored already sent
- first octet of the message PDU
- message reference number
- arrival time of the message to the SC

- sending time of the message
- message status as coded in the PDU
- Protocol Identifier
- Data Coding Scheme
- Originator address, string type represented in the currently selected

character set (see +CSCS)

- Destination address, string type represented in the currently

selected character set (see +CSCS)

- Service Centre number
,, - type of number ,,
129 - number in national format
145 - number in international format (contains the "+")
- text length
- message text

Note: the command differs from the +CMGR because after the message
or a is put before the OK result code.

Note: in both cases if status of the message is 'received unread', status in
the storage changes to 'received read'.

Note: an error result code is sent on empty record .

AT@CMGR=?

Test command has no effect; the answer is OK

Reference GSM

07.05