81 rtc status - #rtcstat – Rainbow Electronics GM862-QUAD-PY User Manual

Page 308

AT Commands Reference Guide

80000ST10025a Rev. 5 - 09/07/08

page 308 of 434

#GPPPCFG - PPP-GPRS Parameters Configuration

SELINT 2

1 - active mode, the module starts autonomously the LCP negotiation

immediately after the CONNECT message

Note: if =”0.0.0.0” (factory default) the Host IP Address
assigned to the host application is the previous remote IP Address
obtained by the Network.

AT# GPPPCFG?

Read command reports the current PPP-GPRS connection parameters in
the format:

#GPPPCFG: ,,

AT# GPPPCFG=?

Test command returns the range of supported values for parameter
and , in the format:

#PPPCFG: “”,(10-600),(0,1)

3.5.7.1.81 RTC Status - #RTCSTAT

#RTCSTAT - RTC Status

SELINT 0 / 1

AT#RTCSTAT[=
]

Set command resets the RTC status flag.

Parameter:

0 - Set RTC Status to RTC HW OK

Note: the initial value of RTC status flag is RTC HW Error and it doesn’t
change until a command AT#RTCSTAT=0 is issued.

Note: if a power failure occurs and the buffer battery is down the RTC
status flag is set to 1. It doesn’t change until command AT#RTCSTAT=0 is
issued.

Note: if parameter is omitted the behaviour of Set command is
the same as Read command.

AT#RTCSTAT?

Read command reports the current value of RTC status flag, in the format:

#RTCSTAT:

AT#RTCSTAT=?

Test command returns the range of supported values for parameter

#RTCSTAT - RTC Status

SELINT 2