Rainbow Electronics GM862-QUAD-PY - Manual (Page 373)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 373 of 434
#EMAILD - E-mail Sending SELINT 2
It is also possible to send an e-mail on the GSM context, if it has already
been activated by AT#SGACT=0,1.
Parameters:
- destination address, string type.
- subject of the message, string type
- attached image flag; if is present and not empty,
is assumed to be always 1, no matter what value it really is.
0 - don't attach any image
1 - attach the last snapshot taken
- attached image file name on remote party (default is
“snapshot.jpg”)
The device responds to the command with the prompt '>' and awaits for
the message body text.
To complete the operation send Ctrl-Z char (0x1A hex); to exit without
writing the message send ESC char (0x1B hex).
If e-mail message is successfully sent, then the response is OK.
If message sending fails for some reason, an error code is reported
Note: Care must be taken to ensure that during the command execution,
no other commands are issued.
To avoid malfunctions is suggested to wait for the OK or ERROR / +CMS
ERROR: response before issuing further commands.
Note: sending an e-mail with an image attachment can take quite a long
time since it can be over 50Kb to send and can take more than 1 minute.
AT#EMAILD=? Test command returns the OK result code.
Example AT#EMAILD=”[email protected]”,”subject of the mail”,1
>message body… this is the text of the mail message…
CTRL-Z
..wait..
OK
Message has been sent.
Note The only difference between this command (set using GPRS context) and
the #SEMAIL is that this command does not interact with the GPRS context
status, leaving it ON or OFF according to the #EMAILACT (#SGACT)
setting, thus, when the connection made with #EMAILD is closed, the
context status is maintained.
3.5.7.6.8 E-mail Parameters Save - #ESAV
#ESAV - E-mail Parameters Save SELINT 0 / 1