Rainbow Electronics GM862-QUAD-PY - Manual (Page 391)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 391 of 434
#CSURVBC - BCCH Network Survey (Numeric Format) SELINT 0 / 1
AT#CSURVBC=? Test command reports the range of values for parameter in the format:
(1-M)
where M is the maximum number of available frequencies depending on last
selected band.
#CSURVBC - BCCH Network Survey (Numeric Format)
SELINT 2
AT#CSURVBC=
[] Execution command performs a quick network survey through M (maximum
number of available frequencies depending on last selected band) channels.
The survey stops as soon as BCCH carriers are found.
The result is given in numeric format and is like command #CSURVC.
Parameter:
- number of desired BCCH carriers
1..M
AT#CSURVBC=? Test command reports the range of values for parameter in the format:
(1-M)
where M is the maximum number of available frequencies depending on last
selected band.
3.5.7.7.7 Network Survey Format - #CSURVF
#CSURVF - Network Survey Format SELINT 0 / 1
AT#CSURVF[=
[]] Set command controls the format of the numbers output by all the Easy
Scan®
Parameter:
- numbers format
0 - Decimal
1 - Hexadecimal values, no text
2 - Hexadecimal values with text
Note: issuing AT#CSURVF is the same as issuing the Read
command.
Note: issuing AT#CSURVF= is the same as issuing the command
AT#CSURVF=0.
AT#CSURVF? Read command reports the current number format, as follows:
#CSURVF:
AT#CSURVF=? Test command reports the supported range of values for the parameter
.