Rainbow Electronics GM862-QUAD-PY - Manual (Page 301)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 301 of 434
#NITZ - Network Timezone SELINT 2
2 - enables Full Network Name applying
4 - it sets the #NITZ URC ‘extended’ format (see below)
0 - disables #NITZ URC (factory default)
1 - enables #NITZ URC; after date and time updating the following
unsolicited indication is sent:
#NITZ:
where:
- string whose format depends on subparameter
“yy/MM/dd,hh:mm:ss” - ‘basic’ format, if is in (0..3)
“yy/MM/dd,hh:mm:ss±zz” - ‘extended’ format, if is in (4..7)
where:
yy - year
MM - month (in digits)
dd - day
hh - hour
mm - minute
ss - second
zz - time zone (indicates the difference, expressed in quarter of an
hour, between the local time and GMT; two last digits are
mandatory, range is -47..+48)
AT#NITZ? Read command reports whether (a) automatic date/time updating, (b) Full
Network Name applying, (c) #NITZ URC (as well as its format) are currently
enabled or not, in the format:
#NITZ: ,
AT#NITZ=? Test command returns supported values of parameters and .
3.5.7.1.74 Enhanced Network Selection - #ENS
#ENS - Enhanced Network Selection SELINT 2
AT#ENS=[] Set command is used to activate the ENS functionality.
Parameter:
0 - disable ENS functionality (default)
1 - enable ENS functionality; if AT#ENS=1 has been issued, the following
values will be automatically set:
¾ at every next power-up
a Band GSM 850 and PCS enabled (AT#BND=3)
b SIM Application Toolkit enabled on user interface 0 if not previously
enabled on a different user interface (AT#STIA=2)
¾ just at first next power-up
a Automatic Band Selection enabled (AT#AUTOBND=1) only if the