Rainbow Electronics GM862-QUAD-PY - Manual (Page 223)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 223 of 434
+CMSS - Send Message From Storage SELINT 2
AT+CMSS=
[,
[,]] Execution command sends to the network a message which is already
stored in the storage (see +CPMS) at the location .
Parameters:
- location value in the message storage of the message
to send
- destination address, string type represented in the currently selected
character set (see +CSCS); if it is given it shall be used instead of the
one stored with the message.
- type of destination address
129 - number in national format
145 - number in international format (contains the "+")
If message is successfully sent to the network then the result is sent in the
format:
+CMSS:
where:
- message reference number.
If message sending fails for some reason, an error code is reported:
+CMS ERROR:
Note: to store a message in the storage see command +CMGW.
Note: care must be taken to ensure that during the command execution,
which may take several seconds, no other SIM interacting commands are
issued.
AT+CMSS=? Test command resturns the OK result code.
Note To avoid malfunctions is suggested to wait for the +CMSS: or +CMS
ERROR: response before issuing further commands.
Reference GSM 07.05
3.5.5.4.3 Write Message To Memory - +CMGW
+CMGW - Write Message To Memory SELINT 0 / 1
(PDU Mode)
AT+CMGW=
[,] (PDU Mode)
Execution command writes in the memory storage a new
message.
Parameter:
- length in bytes of the PDU to be written.
7..164
- message status.
0 - new message
1 - read message