48 automatic call - #acal – Rainbow Electronics GM862-QUAD-PY User Manual

Page 283

AT Commands Reference Guide

80000ST10025a Rev. 5 - 09/07/08

page 283 of 434

#DIALMODE - Dialing Mode

SELINT 2

#DIALMODE:

AT#DIALMODE=?

Test command returns the range of values for parameter

3.5.7.1.48 Automatic Call - #ACAL

#ACAL - Automatic Call

SELINT 0 / 1

AT#ACAL[=
[]]

Set command enables/disables the automatic call function.

Parameter:

0 - disables the automatic call function (factory default)
1 - enables the automatic call function. If enabled (and &D2 has been

issued), the transition OFF/ON of DTR causes an automatic call to the
first number (position 0) stored in the internal phonebook.

Note: type of call depends on the last issue of command +FCLASS.

Note: issuing AT#ACAL is the same as issuing the Read command.

Note: issuing AT#ACAL= is the same as issuing the command
AT#ACAL=0.

AT#ACAL?

Read command reports whether the automatic call function is currently
enabled or not, in the format:

#ACAL:

AT#ACAL=?

Test command returns the supported range of values for parameter

Note See

&Z to write and &N to read the number on module internal phonebook.