Rainbow Electronics GM862-QUAD-PY - Manual (Page 418)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 418 of 434
#CMUXSCR - CMUX Interface Enable SELINT 2
,[] channel (see +CMUX) at startup before the current script (see #ESCRIPT)
execution and specifies the DTE speed at which the device sends and
receives CMUX frames (used to fix the DTE-DCE interface speed).
Parameters:
- enables/disables CMUX interface at startup.
0 - it disables CMUX interface at startup, before current script execution
(factory default)
1 - it enables CMUX interface at startup, before current script execution
300
1200
2400
4800
9600
19200
38400
57600
115200 (default)
If is omitted the value is unchanged
and values are saved in NVM
AT#CMUXSCR ? Read command returns the current value of #CMUXSCR parameters in the
format:
#CMUXSCR: ,
AT#CMUXSCR =? Test command reports the range for the parameters and
3.5.7.11 GPS AT Commands Set
3.5.7.11.1 GPS Controller Power Management - $GPSP
$GPSP - GPS Controller Power Management SELINT 0 / 1 / 2
AT$GPSP=
Set command allows to manage power-up or down of the GPS controller
Parameter:
0 - GPS controller is powered down
1 - GPS controller is powered up (default)
Note: for the GPS product (GE863-GPS): if the GPS controller is powered
down while VAUX pin is enabled they’ll both also be also powered off.