Rainbow Electronics GM862-QUAD-PY - Manual (Page 315)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 315 of 434
#NWSCANTMR:
AT#NWSCANTMR=? Test command reports the supported range of values for parameter
Note How much time it takes to execute the network scan depends either on how
much bands have been selected and on network configuration (mean value
is 5 seconds)
3.5.7.2 General Configuration AT Commands - Special Issues
Following commands are available only for specific subsets of products, as it appears in the ‘Note’
3.5.7.2.1 External 32kHz Oscillator
#OSC32KHZ - External 32kHz Oscillator SELINT 2
AT#OSC32KHZ Execution command reports the presence of an external 32kHz oscillator, in
the format:
#OSC32KHZ:
where:
0 - external 32kHz oscillator is not present
1 - external 32kHz oscillator is present
Note: if the external oscillator is removed while the module is on, the
software will take up to 9 seconds to realize its absence.
Note: if the external oscillator is connected to the module while it is on, the
software will take less than 1 second to realize its presence.
AT#OSC32KHZ=? Test command returns the OK result code.
Note This command is currently available only for the product GE864-AUTO
3.5.7.3 Multisocket AT Commands
3.5.7.3.1 Socket Status - #SS
#SS - Socket Status SELINT 2
AT#SS
Execution command reports the current status of the sockets in the format:
#SS: ,,,,,
[,,,,,
[…]]
where: