Rainbow Electronics GM862-QUAD-PY - Manual (Page 184)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 184 of 434
+CSAS - Save Settings SELINT 2
are always saved to NVM, regardless the value of .
Note: If parameter is omitted the settings are saved in the non volatile
memory.
AT+CSAS=? Test command returns the possible range of values for the parameter
.
Reference GSM 07.05
3.5.5.2.6 Restore Settings - +CRES
+CRES - Restore Settings SELINT 0 / 1
AT+CRES
[=]
Execution command restores message service settings saved by +CSCA
command from either NVM or SIM.
Parameter:
0 - it restores message service settings from NVM.
1..n - it restores message service settings from SIM. The value of n
depends on the SIM and its max is 3.
Note: certain settings may not be supported by the SIM and therefore they
are always restored from NVM, regardless the value of .
Note: If parameter is omitted the command restores message service
settings from NVM.
AT+CRES? Read command has the same effect as Execution command with parameter
omitted.
AT+CRES=? Test command returns the possible range of values for the parameter
.
Reference GSM 07.05
+CRES - Restore Settings
SELINT 2
AT+CRES
[=] Execution command restores message service settings saved by +CSAS
command from either NVM or SIM.
Parameter:
0 - it restores message service settings
from NVM.
1..n - it restores message service settings from SIM. The value of n
depends on the SIM and its max is 3.
Note: certain settings may not be supported by the SIM and therefore they
are always restored from NVM, regardless the value of .
Note: If parameter is omitted the command restores message service