Rainbow Electronics GM862-QUAD-PY - Manual (Page 49)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 49 of 434
+IFC - DTE-Modem Local Flow Control SELINT 0 / 1 / 2
AT+IFC=? Test command returns all supported values of the parameters
and .
Reference V25ter
3.5.3.2.14 DTE-Modem Local Rate Reporting - +ILRR
+ILRR - DTE-Modem Local Rate Reporting SELINT 0 / 1 / 2
AT+ILRR= Set command controls whether or not the +ILRR: information text is
transmitted from the modem (module) to the DTE.
Parameter:
0 - local port speed rate reporting disabled (factory default)
1 - local port speed rate reporting enabled
Note: If AT+IPR=0 (in autobauding) local port speed reported will be 0.
Note: this information if enabled is sent upon connection.
AT+ILRR? Read command returns active setting of .
AT+ILRR=? Test command returns all supported values of the parameter
Reference V25ter
3.5.3.2.15 DTE-Modem Character Framing - +ICF
+ICF - DTE-Modem Character Framing SELINT 0 / 1 / 2
AT+ICF=
[,] Set command defines the asynchronous character framing to be used when
autobauding is disabled.
Parameters:
- determines the number of bits in the data bits, the presence of a
parity bit, and the number of stop bits in the start-stop frame.
0 - autodetection
1 - 8 Data, 2 Stop
2 - 8 Data, 1 Parity, 1 Stop
3 - 8 Data, 1 Stop
5 - 7 Data, 1 Parity, 1 Stop
- determines how the parity bit is generated and checked, if
present; setting this subparameter is mandatory and has a
meaning only if subparameter is either 2 or 5.
0 - Odd
1 - Even
AT+ICF? Read command returns current settings for subparameters and
. If current setting of subparameter is neither 2 nor 5, the
current setting of subparameter will always represented as 0.
AT+ICF=? Test command returns the ranges of values for the parameters
and
Reference V25ter