Rainbow Electronics GM862-QUAD-PY - Manual (Page 279)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 279 of 434
#SERVINFO - Serving Cell Information SELINT 0 / 1
..0
..3..6
AT#SERVINFO? Read command has the same effect as Execution command
#SERVINFO - Serving Cell Information SELINT 2
AT#SERVINFO Execution command reports information about serving cell, in the format:
#SERVINFO: ,,,,
,,,,[,[],[],
,[PAT]]
where:
- BCCH ARFCN of the serving cell
- received signal strength in dBm
- operator name, quoted string type
- country code and operator code, hexadecimal
representation
- Base Station Identification Code
- Localization Area Code
- Time Advance: it’s available only if a GSM or GPRS is running
- GPRS supported in the cell
0 - not supported
1 - supported
The following information will be present only if GPRS is supported in the
cell
- PBCCH ARFCN of the serving cell; it’ll be printed only if
PBCCH is supported by the cell, otherwise the label “hopping” will
be printed
- Network Operation Mode
..”I”
“II”
..”III”
- Routing Area Colour Code
- Priority Access Threshold
..0
..3..6
3.5.7.1.45 +COPS Mode - #COPSMODE
#COPSMODE - +COPS Mode SELINT 0 / 1
AT#COPSMODE
[=] Set command sets the behaviour of +COPS command (see +COPS).
Parameter:
0 - +COPS behaviour like former GM862 family products (default)