Rainbow Electronics GM862-QUAD-PY - Manual (Page 287)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 287 of 434
#SMOV - SMS Overflow SELINT 0 / 1
currently enabled or not, in the format:
#SMOV:
AT#SMOV=? Test command returns the supported range of values of parameter
.
#SMOV - SMS Overflow
SELINT 2
AT#SMOV=
[] Set command enables/disables the SMS overflow signalling function.
Parameter:
0 - disables SMS overflow signaling function (factory default)
1 - enables SMS overflow signalling function; when the maximum storage
capacity has reached, the following network initiated notification is send:
#SMOV:
AT#SMOV? Read command reports whether the SMS overflow signalling function is
currently enabled or not, in the format:
#SMOV:
AT#SMOV=? Test command returns the supported range of values of parameter .
3.5.7.1.52 Mailbox Numbers - #MBN
#MBN - Mailbox Numbers SELINT 2
AT#MBN Execution command returns the mailbox numbers stored on SIM, if this
service is provided by the SIM.
The response format is:
[#MBN: ,,[,][,mboxtype][
#MBN: ,,[,][,mboxtype][…]]]
where:
- record number
- string type mailbox number in the format
- type of mailbox number octet in integer format
129 - national numbering scheme
145 - international numbering scheme (contains the character "+")
- the alphanumeric text associated to the number; used character set
should be the one selected with command +CSCS
- the message waiting group type of the mailbox, if available:
"VOICE" - voice
"FAX" - fax
"EMAIL" - electronic mail
"OTHER" - other
Note: if all queried locations are empty (but available), no information text