Rainbow Electronics GM862-QUAD-PY - Manual (Page 271)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 271 of 434
#CBC- Battery And Charger Status SELINT 0 / 1
AT#CBC? Read command has the same meaning as Execution command.
AT#CBC=? Test command returns the OK result code.
#CBC- Battery And Charger Status
SELINT 2
AT#CBC Execution command returns the current Battery and Charger state in the
format:
#CBC: ,
where:
- battery charger state
0 - charger not connected
1 - charger connected and charging
2 - charger connected and charge completed
- battery voltage in units of ten millivolts: it is the real
battery voltage only if charger is not connected; if the charger is
connected this value depends on the charger voltage.
AT#CBC=? Test command returns the OK result code.
3.5.7.1.41 GPRS Auto-Attach Property - #AUTOATT
#AUTOATT - Auto-Attach Property SELINT 0 / 1
AT#AUTOATT
[=] Set command enables/disables the TE GPRS auto-attach property.
Parameter:
0 - disables GPRS auto-attach property
1 - enables GPRS auto-attach property (factory default): after the
command #AUTOATT=1 has been issued (and at every following
startup) the terminal will automatically try to attach to the GPRS service.
Note: If parameter is omitted then the behaviour of Set command is the
same as Read command.
AT#AUTOATT? Read command reports whether the auto-attach property is currently
enabled or not, in the format:
#AUTOATT:
AT#AUTOATT=? Test command reports available values for parameter .
#AUTOATT - Auto-Attach Property
SELINT 2
AT#AUTOATT=
[] Set command enables/disables the TE GPRS auto-attach property.
Parameter:
0 - disables GPRS auto-attach property
1 - enables GPRS auto-attach property (factory default): after the