Rainbow Electronics GM862-QUAD-PY - Manual (Page 281)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 281 of 434
#QSS - Query SIM Status SELINT 2
AT#QSS=
[] Set command enables/disables the Query SIM Status unsolicited indication
in the ME.
Parameter:
- type of notification
0 - disabled (factory default); it’s possible only to query the current SIM
status through Read command AT#QSS?
1 - enabled; the ME informs at every SIM status change through the
following basic unsolicited indication:
#QSS:
where:
- current SIM status
0 - SIM NOT INSERTED
1 - SIM INSERTED
2 - enabled; the ME informs at every SIM status change through the
following unsolicited indication:
#QSS:
where:
- current SIM status
0 - SIM NOT INSERTED
1 - SIM INSERTED
2 - SIM INSERTED and PIN UNLOCKED
3 - SIM INSERTED and READY (SMS and Phonebook access
are possible).
AT#QSS? Read command reports whether the unsolicited indication #QSS is currently
enabled or not, along with the SIM status, in the format:
#QSS: ,
( and are described above)
AT#QSS=? Test command returns the supported range of values for parameter
.
3.5.7.1.47 ATD Dialing Mode - #DIALMODE
#DIALMODE - ATD Dialing Mode SELINT 0 / 1
AT#DIALMODE[=
] Set command sets ATD modality.
Parameter:
0 - (voice call only) OK result code is received as soon as it starts remotely
ringing (factory default)