Rainbow Electronics GM862-QUAD-PY - Manual (Page 243)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 243 of 434
#CAP - Change Audio Path SELINT 0 / 1
AT#CAP? Read command reports the active audio path in the format:
#CAP: .
AT#CAP=? Test command reports the supported values for the parameter .
#CAP - Change Audio Path
SELINT2
AT#CAP=[] Set command switches the active audio path depending on parameter
Parameter:
- audio path
0 - audio path follows the AXE input (factory default):
• if AXE is low, handsfree is enabled;
• if AXE is high, internal path is enabled
1 - enables handsfree external mic/ear audio path
2 - enables internal mic/ear audio path
Note: The audio path are mutually exclusive, enabling one disables the
other.
Note: when changing the audio path, the volume level is set at the
previously stored value for that audio path (see +CLVL).
AT#CAP? Read command reports the active audio path in the format:
#CAP: .
AT#CAP=? Test command reports the supported values for the parameter .
3.5.7.1.11 Select Ringer Sound - #SRS
#SRS - Select Ringer Sound SELINT 0 / 1
AT#SRS[=
,] Set command sets the ringer sound.
Parameters:
- ringing tone
0 - current ringing tone
1..max - ringing tone number, where max can be read by issuing the Test
command AT#SRS=?.
- ringing tone playing time-out in seconds.
0 - ringer is stopped (if present) and current ringer sound is set.
1..60 - ringer sound playing for seconds and, if > 0, ringer
sound is set as default ringer sound.
Note: when the command is issued with > 0 and > 0, the
ringing tone is played for seconds and stored as default ringing tone.
Note: if command is issued with > 0 and = 0, the playing of the
ringing is stopped (if present) and ringing tone is set as current.