Rainbow Electronics GM862-QUAD-PY - Manual (Page 147)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 147 of 434
3.5.4.4.23 Read ICCID (Integrated Circuit Card Identification) - +CCID
+CCID - Read ICCID (Integrated Circuit Card Identification) SELINT 0 / 1
AT+CCID Execution command reads on SIM the ICCID (card identification number
that provides a unique identification number for the SIM)
AT+ CCID? Read command has the same effect as Execution command.
AT+CCID=? Test command reports OK.
3.5.4.5 Mobile Equipment Errors
3.5.4.5.1 Report Mobile Equipment Error - +CMEE
+CMEE - Report Mobile Equipment Error SELINT 0 / 1
AT+CMEE[=[]] Set command enables/disables the report of result code:
+CME ERROR:
as an indication of an error relating to the +Cxxx commands issued.
When enabled, device related errors cause the +CME ERROR: final
result code instead of the default ERROR final result code. ERROR is
anyway returned normally when the error message is related to syntax,
invalid parameters, or DTE functionality.
Parameter:
- enable flag
0 - disable +CME ERROR: reports, use only ERROR report.
1 - enable +CME ERROR: reports, with in numeric format
2 - enable +CME ERROR: reports, with in verbose format
Note: issuing AT+CMEE is the same as issuing the Read command.
Note: issuing AT+CMEE= is the same as issuing the command
AT+CMEE=0.
AT+CMEE? Read command returns the current value of subparameter
+CMEE:
AT+CMEE=? Test command returns the range of values for subparameter in the
format:
+CMEE: 0, 1, 2
Note: the representation format of the Test command output is not included
in parenthesis.
Note +CMEE has no effect on the final result code +CMS
Reference GSM 07.07