Rainbow Electronics GM862-QUAD-PY - Manual (Page 162)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 162 of 434
+CGQREQ - Quality Of Service Profile (Requested) SELINT 2
OK
AT+CGQREQ=1,0,0,3,0,0
OK
AT+CGQREQ=?
+CGQREQ: ”IP”,(0-3),(0-4),(0-5),(0-9),(0-18,31)
OK
Reference GSM 07.07; GSM 03.60
3.5.4.7.8 PDP Context Activate Or Deactivate - +CGACT
+CGACT - PDP Context Activate Or Deactivate SELINT 0 / 1
AT+CGACT[=
[[,
[,[,…]]]]] Execution command is used to activate or deactivate the specified PDP
context(s)
Parameters:
- indicates the state of PDP context activation
0 - deactivated
1 - activated
- a numeric parameter which specifies a particular PDP context
definition (see +CGDCONT)
Note: if no s are specified the activation/deactivation form of the
command activates/deactivates all defined contexts.
Note: issuing AT+CGACT is the same as issuing the Read command.
Note: issuing AT+CGACT= returns the OK result code.
AT+CGACT? Read command returns the current activation state for all the defined PDP
contexts in the format:
+CGACT: ,[+CGACT:
,[…]]
AT+CGACT=? Test command reports information on the supported PDP context activation
states parameters in the format:
+CGACT: (0-1)
Example
AT+CGACT?
+CGACT: 1,1
OK
AT+CGACT=1,1
OK
Reference GSM 07.07
+CGACT - PDP Context Activate Or Deactivate
SELINT 2