Rainbow Electronics GM862-QUAD-PY - Manual (Page 299)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 299 of 434
3.5.7.1.70 Handset Noise Reduction - #SHSNR
#SHSNR - Handset Noise Reduction SELINT 2
AT# SHSNR =
Set command enables/disables the noise reduction function on audio
handset input.
Parameter:
0 - disables noise reduction for handset mode (default)
1 - enables noise reduction for handset mode
Note: This parameter is saved in NVM issuing AT&W command.
AT# SHSNR? Read command reports whether the noise reduction function on audio
handset input is currently enabled or not, in the format:
# SHSNR:
AT# SHSNR =? Test command returns the supported range of values of parameter
.
3.5.7.1.71 Set Handset Sidetone - #SHSSD
#SHSSD - Set Handset Sidetone SELINT 2
AT#SHSSD=
Set command enables/disables the sidetone on handset audio output.
Parameter:
0 - disables the handset sidetone
1 - enables the handset sidetone (factory default)
Note: This parameter is saved in NVM issuing AT&W command.
AT#SHSSD? Read command reports whether the headset sidetone is currently enabled
or not, in the format:
#SHSSD:
AT#SHSSD=? Test command returns the supported range of values of parameter
.
3.5.7.1.72 Repeat Last Command - #/
#/ - Repeat Last Command SELINT 0 / 1 / 2
AT#/ Execute command is used to execute again the last received command.
3.5.7.1.73 Network Timezone - #NITZ
#NITZ - Network Timezone SELINT 0 / 1
AT#NITZ[=
[ Set command enables/disables automatic date/time updating and Network
Timezone unsolicited indication.