23 tcp reassembly - #tcpreass, 6 e-mail management at commands, 1 e-mail smtp server - #esmtp – Rainbow Electronics GM862-QUAD-PY User Manual

Page 363

background image




AT Commands Reference Guide

80000ST10025a Rev. 5 - 09/07/08

Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved

page 363 of 434

#TCPMAXDAT - Maximum TCP Payload Size

SELINT 2


#TCPMAXDAT:

AT#TCPMAXDAT=? Test command reports the supported range of values for parameter

3.5.7.5.23 TCP Reassembly - #TCPREASS

#TCPREASS - TCP Reassembly

SELINT 2

AT#TCPREASS=

Set command enables/disables the TCP reassembly feature, in order to
handle fragmented TCP packets.

Parameter:

0 - disable TCP reassembly feature (default)
1 - enable TCP reassembly feature

AT#TCPREASS?

Read command returns whether the TCP reassembly feature is enabled or
not, in the format:

#TCPREASS:

AT#TCPREASS=?

Test command returns the supported range of values for parameter .




3.5.7.6 E-mail Management AT Commands

3.5.7.6.1 E-mail SMTP Server - #ESMTP

#ESMTP - E-mail SMTP Server

SELINT 0 / 1

AT#ESMTP
[=]

Set command sets the SMTP server address, used for E-mail sending.
SMTP server can be specified as IP address or as nick name.

Parameter:
- SMTP server address, string type. This parameter can be either:

-

any valid IP address in the format: xxx.xxx.xxx.xxx

- any host name to be solved with a DNS query in the format:

name>

(factory default is the empty string “”)


Note: the max length for is the output of Test command.

Note: If parameter is omitted then the behaviour of Set command is the
same of Read command

AT#ESMTP?

Read Command reports the current SMTP server address, in the format:

See also other documents in the category Rainbow Electronics GPS receiver: