Rainbow Electronics GM862-QUAD-PY - Manual (Page 263)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 263 of 434
#E2SMSRI - SMS Ring Indicator SELINT 0 / 1
Note: as seen before, the value =0 means that the RI pin response to
an incoming SM is disabled.
AT#E2SMSRI=? Reports the range of supported values for parameter
#E2SMSRI - SMS Ring Indicator
SELINT 2
AT#E2SMSRI=
[] Set command enables/disables the Ring Indicator pin response to an
incoming SMS message. If enabled, a negative going pulse is generated on
receipt of an incoming SMS message. The duration of this pulse is
determined by the value of .
Parameter:
- RI enabling
0 - disables RI pin response for incoming SMS messages (factory default)
50..1150 - enables RI pin response for incoming SMS messages. The
value of is the duration in ms of the pulse generated on receipt of
an incoming SM.
Note: if +CNMI=3,1 command is issued and the module is in a GPRS
connection, a 100 ms break signal is sent and a 1 sec. pulse is generated
on RI pin, no matter if the RI pin response is either enabled or not.
AT#E2SMSRI? Read command reports the duration in ms of the pulse generated on
receipt of an incoming SM, in the format:
#E2SMSRI:
Note: as seen before, the value =0 means that the RI pin response to
an incoming SM is disabled.
AT#E2SMSRI=? Reports the range of supported values for parameter
3.5.7.1.32 Analog/Digital Converter Input - #ADC
#ADC - Analog/Digital Converter Input SELINT 0 / 1
AT#ADC[=
,
[, Execution command reads pin voltage, converted by ADC, and
outputs it in the format:
#ADC:
where:
- pin voltage, expressed in mV
Parameters:
- index of pin
1 - available for GM862-QUAD, GM862-QUAD-PY, GM862-GPS, GE863-
QUAD, GE863-PY,GE863-GPS, GE864-QUAD, GE864-PY, GC864-
QUAD and GC864-PY