Rainbow Electronics GM862-QUAD-PY - Manual (Page 329)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 329 of 434
#FTPGET - FTP Get SELINT 2
The file is received on the serial port.
Parameter:
- file name, string type.
Note: The command causes an ERROR result code to be returned in case
no FTP connection has been opened yet.
Note: Command closure should always be handled by application. In order
to avoid download stall situations a timeout should be implemented by the
application.
AT#FTPGET=? Test command returns the OK result code.
3.5.7.4.6 FTP Type - #FTPTYPE
#FTPTYPE - FTP Type SELINT 0 / 1
AT#FTPTYPE[=
] Set command, issued during an FTP connection, sets the file transfer type.
Parameter:
- file transfer type:
0 - binary
1 - ascii
Note: The command causes an ERROR result code to be returned if no
FTP connection has been opened yet.
Note: If the parameter is omitted then the behaviour of Set command is the
same of Read command.
#FTPTYPE? Read command returns the current file transfer type, in the format:
#FTPTYPE:
#FTPTYPE=? Test command returns the range of available values for parameter :
#FTPTYPE: (0,1)
#FTPTYPE - FTP Type
SELINT 2
AT#FTPTYPE=
[] Set command, issued during an FTP connection, sets the file transfer type.
Parameter:
- file transfer type:
0 - binary
1 - ascii
Note: The command causes an ERROR result code to be returned if no
FTP connection has been opened yet.
#FTPTYPE? Read command returns the current file transfer type, in the format: