Rainbow Electronics GM862-QUAD-PY - Manual (Page 81)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 81 of 434
+CREG - Network Registration Report SELINT 0 / 1
- Local Area Code for the currently registered on cell
- Cell Id for the currently registered on cell
Note: and are reported only if =2 and the mobile is
registered on some network cell.
Note: issuing AT+CREG is the same as issuing the Read command.
Note: issuing AT+CREG= is the same as issuing the command
AT+CREG=0.
AT+CREG? Read command reports the and parameter values in the
format:
+CREG: ,[,,]
Note: and are reported only if =2 and the mobile is
registered on some network cell.
AT+CREG=? Test command returns the range of supported
Example AT
OK
at+creg?
+CREG: 0,2
OK
(the MODULE is in network searching state)
at+creg?
+CREG: 0,2
OK
at+creg?
+CREG: 0,2
OK
at+creg?
+CREG: 0,2
OK
at+creg?
+CREG: 0,1
OK
(the MODULE is registered )
at+creg?
+CREG: 0,1
OK
Reference GSM 07.07
+CREG - Network Registration Report
SELINT 2
AT+CREG= Set command enables/disables network registration reports depending on