Rainbow Electronics GM862-QUAD-PY - Manual (Page 141)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 141 of 434
+CRSL - Ringer Sound Level SELINT 1
Note: an enhanced version of Test command has been defined:
AT+CRSL=??.
AT+CRSL=?? Enhanced Test command returns the complete range of supported values
for the parameter :
+CRSL: (0-4)
Reference GSM 07.07
+CRSL - Ringer Sound Level
SELINT 2
AT+CRSL= Set command is used to select the incoming call ringer sound level of the
device.
Parameter:
- ringer sound level
0 - Off
1 - low
2 - middle
3 - high
4 - progressive
AT+CRSL? Read command reports the current setting of the call ringer in the
format:
+CRSL:
AT+CRSL=? Test command reports supported values as compound value.
+CRSL: (0-4)
Reference GSM 07.07
3.5.4.4.16 Loudspeaker Volume Level - +CLVL
+CLVL - Loudspeaker Volume Level SELINT 0 / 1
AT+CLVL[=
] Set command is used to select the volume of the internal loudspeaker audio
output of the device.
Parameter:
- loudspeaker volume
0..max - the value of max can be read by issuing the Test command
AT+CLVL=?
Note: If the parameter is omitted the behavior of Set command is the same
as Read command.
AT+CLVL? Read command reports the current setting of the loudspeaker
volume in the format:
+CLVL:
AT+CLVL=? Test command reports supported values range in the format: