Rainbow Electronics GM862-QUAD-PY - Manual (Page 253)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 253 of 434
#WAKE - Wake From Alarm Mode SELINT 2
AT#WAKE? Read command returns the operating status of the device in the format:
#WAKE:
where:
0 - normal operating mode
1 - alarm mode or normal operating mode with some alarm activity.
3.5.7.1.23 Query Temperature Overflow - #QTEMP
#QTEMP - Query Temperature Overflow SELINT 0 / 1
AT#QTEMP
[=] Set command has currently no effect. The interpretation of parameter
is currently not implemented.
Note: if parameter is omitted the behaviour of Set command is the
same as Read command
Note: Only =0 is accepted.
AT#QTEMP? Read command queries the device internal temperature sensor for over
temperature and reports the result in the format:
#QTEMP:
where
- over temperature indicator
0 - the device temperature is in the working range
1 - the device temperature is out of the working range
Note: typical temperature working range is (-10°C..+55°C); anyway you are
strongly recommended to consult the “Hardware User Guide” to verify the
real temperature working range of your module
#QTEMP=? Test command reports supported range of values for parameter .
Note The device should not be operated out of its temperature working range; if
temperature is out of range proper functioning of the device is not ensured.
#QTEMP - Query Temperature Overflow
SELINT 2
AT#QTEMP=
[] Set command has currently no effect. The interpretation of parameter
is currently not implemented: any value assigned to it will simply
have no effect.
AT#QTEMP? Read command queries the device internal temperature sensor for over
temperature and reports the result in the format:
#QTEMP:
where