Rainbow Electronics GM862-QUAD-PY - Manual (Page 111)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 111 of 434
+CCUG - Closed User Group Supplementary Service Control SELINT 2
0..9 - CUG index
10 - no index (preferential CUG taken from subscriber data) (default)
0 - no information (default)
1 - suppress Outgoing Access (OA)
2 - suppress preferential CUG
3 - suppress OA and preferential CUG
AT+CCUG? Read command reports the current value of the parameters
AT+CCUG=? Test command returns the OK result code
Reference GSM 07.07
3.5.4.3.18 Preferred Operator List - +CPOL
+CPOL - Preferred Operator List SELINT 2
AT+CPOL=
[][,
[,]]
Execution command writes an entry in the SIM list of preferred operators.
Parameters:
- integer type; the order number of operator in the SIM preferred
operator list
1..n
2 - numeric
- string type
Note: if is given but is left out, entry is deleted. If is
given but is left out, is put in the next free location. If only
is given, the format of the in the read command is
changed.
AT+CPOL? Read command returns all used entries from the SIM list of preferred
operators.
AT+CPOL=? Test command returns the whole range supported by the SIM and
the range for the parameter
Reference GSM 07.07
3.5.4.4 Mobile Equipment Control
3.5.4.4.1 Phone Activity Status - +CPAS
+CPAS - Phone Activity Status SELINT 0 / 1
AT+CPAS Execution command reports the device status in the form:
+CPAS:
Where: