15 ringer sound level - +crsl – Rainbow Electronics GM862-QUAD-PY User Manual
Page 139
AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 139 of 434
+CALM - Alert Sound Mode
SELINT 0 / 1
Note: If parameter is omitted then the behaviour of Set command is the
same as Read command.
AT+CALM?
Read command returns the current value of parameter
AT+CALM=?
Test command returns the supported values for the parameter
compound value.
For compatibility with previous versions, Test command returns
+CALM: (0,1)
An enhanced version of Test command has been defined: AT+CALM=??,
that provides the complete range of values for
AT+CALM=??
Enhanced test command returns the complete range of values for the
parameter
+CALM: (0-2)
Reference GSM
07.07
+CALM - Alert Sound Mode
SELINT 2
AT+CALM=
Set command is used to select the general alert sound mode of the device.
Parameter:
0 - normal mode
1 - silent mode; no sound will be generated by the device, except for alarm
sound
2 - stealth mode; no sound will be generated by the device
Note: if silent mode is selected then incoming calls will not produce alerting
sounds but only the unsolicited messages RING or +CRING.
AT+CALM?
Read command returns the current value of parameter
AT+CALM=?
Test command returns the supported values for the parameter
compound value.
+CALM: (0-2)
Reference GSM
07.07
3.5.4.4.15 Ringer Sound Level - +CRSL
+CRSL - Ringer Sound Level
SELINT 0
AT+CRSL[=
Set command is used to select the incoming call ringer sound level of the
device.
Parameter:
0 - Off