Rainbow Electronics GM862-QUAD-PY - Manual (Page 343)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 343 of 434
#DNS – Manual DNS Selection SELINT 2
AT#DNS=,
,
Set command allows to manually set primary and secondary DNS servers
either for a PDP context defined by +CGDCONT or for a GSM context
defined by #GSMCONT
Parameters:
- context identifier
0 - specifies the GSM context
1..5 - numeric parameter which specifies a particular PDP context
definition
- manual primary DNS server, string type, in the format
“xxx.xxx.xxx.xxx” used for the specified cid; we’re using this
value instead of the primary DNS server come from the
network (default is “0.0.0.0”)
- manual secondary DNS server, string type, in the format
“xxx.xxx.xxx.xxx” used for the specified cid; we’re using
this value instead of the secondary DNS server come from
the network (default is “0.0.0.0”).
Note: if is ”0.0.0.0.0” and is not “0.0.0.0”, then
issuing AT#DNS=… raises an error.
Note: if is ”0.0.0.0.0” we’re using the primary DNS server
come from the network as consequence of a context activation.
Note: if is not ”0.0.0.0” and is “0.0.0.0”, then
we’re using only the manual primary DNS server.
Note: the context identified by has to be previously defined,
elsewhere issuing AT#DNS=… raises an error.
Note: the context identified by has to be not activated yet, elsewhere
issuing AT#DNS=… raises an error.
AT#DNS? Read command returns the manual DNS servers set either for every
defined PDP context and for the single GSM context (only if defined), in the
format:
[#DNS: ,,[
#DNS: ,,]]
AT#DNS=? Test command reports the supported range of values for the
parameter.only, in the format:
#DNS: (0,5),,