1 me error result code - +cme error: Page 11
Page 11
AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 11 of 434
ATCMD1 CMD2=10+CMD1;+CMD2=, ,10;+CMD1?;+CMD1=?
anyway it is always preferable to separate into different command lines the basic commands and the
extended commands; furthermore it is suggested to avoid placing several action commands in the
same command line, because if one of them fails, then an error message is received but it is not
possible to argue which one of them has failed the execution.
If command V1 is enabled (verbose responses codes) and all commands in a command line has been
performed successfully, result code
subparameter values of a command are not accepted by the TA or command itself is invalid, or
command cannot be performed for some reason, result code
and no subsequent commands in the command line are processed.
If command V0 is enabled (numeric responses codes), and all commands in a command line has
been performed successfully, result code 0
values of a command are not accepted by the TA or command itself is invalid, or command cannot be
performed for some reason, result code 4
are processed.
In case of errors depending on ME operation, ERROR (or 4) response may be replaced by +CME
ERROR:
Note: The command line buffer accepts a maximum of 80 characters. If this number is exceeded none
of the commands will be executed and TA returns ERROR.
3.2.2.1 ME Error Result Code - +CME ERROR:
This is NOT a command, it is the error response to +Cxxx GSM 07.07 commands.
Syntax: +CME ERROR:
Parameter:
values of
Numeric Format
Verbose Format
General errors:
0
phone failure
1
No connection to phone
2
phone-adaptor link reserved
3
operation not allowed
4
operation not supported
5
PH-SIM PIN required
10
SIM not inserted
11
SIM PIN required
12
SIM PUK required
13
SIM failure
14
SIM busy
15
SIM wrong
16
incorrect password