Rainbow Electronics GM862-QUAD-PY - Manual (Page 294)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 294 of 434
#SHFSD - Set Headset Sidetone SELINT 2
AT#SHFSD=? Test command returns the supported range of values of parameter
.
3.5.7.1.59 Speaker Mute Control - #SPKMUT
#SPKMUT - Speaker Mute Control SELINT 2
AT#SPKMUT= Set command enables/disables the global muting of the speaker audio line,
for every audio output ( ring, incoming sms, voice, Network coverage)
Parameter:
0 - mute off, speaker active (factory default)
1 - mute on, speaker muted.
Note: this command mutes/activates both speaker audio paths, internal
speaker and external speaker.
AT#SPKMUT? Read command reports whether the muting of the speaker audio line during
a voice call is enabled or not, in the format:
#SPKMUT:
AT#SPKMUT=? Test command reports the supported values for parameter.
3.5.7.1.60 Handsfree Receiver Gain - #HFRECG
#HFRECG - Handsfree Receiver Gain SELINT 2
AT#HFRECG=
Set command sets the handsfree analogue output gain
Parameter:
: handsfree analogue output gain
0..6 - handsfree analogue output (-3dB/step)
Note: This parameter is saved in NVM issuing AT&W command.
AT#HFRECG? Read command returns the current handsfree analog output gain, in the
format:
#HFRECG:
AT#HFRECG =? Test command returns the supported range of values of parameter
.
3.5.7.1.61 Handset Receiver Gain - #HSRECG
#HSRECG - Handset Receiver Gain SELINT 2
AT#HSRECG=
Set command sets the handset analogue output gain
Parameter: