Rainbow Electronics GM862-QUAD-PY User Manual
Page 220
AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 220 of 434
+CMGS - Send Message
SELINT 2
and waits for the specified number of bytes.
Note: the DCD signal shall be in ON state while PDU is given.
Note: the echoing of given characters back from the TA is controlled
by echo command E
Note: the PDU shall be hexadecimal format (each octet of the PDU is
given as two IRA character long hexadecimal number) and given in
one line.
Note: when the length octet of the SMSC address (given in the PDU)
equals zero, the SMSC address set with command +CSCA is used; in
this case the SMSC Type-of-Address octet shall not be present in the
PDU.
To send the message issue Ctrl-Z char (0x1A hex).
To exit without sending the message issue ESC char (0x1B hex).
If message is successfully sent to the network, then the result is sent
in the format:
+CMGS:
where
Reference in integer format.
Note: if message sending fails for some reason, an error code is
reported.
Note: care must be taken to ensure that during the command
execution, which may take several seconds, no other SIM interacting
commands are issued.
#
S
M
S
M
O
D
E
=
1
#
S
M
S
M
O
D
E
=
1
#
S
M
S
M
O
D
E
=
1
#
S
M
S
M
O
(Text Mode)
AT+CMGS=
[,
(Text Mode)
Execution command sends to the network a message.
Parameters:
selected character set (see +CSCS).
129 - number in national format
145 - number in international format (contains the "+")
After command line is terminated with