7 e-mail sending - #emaild – Rainbow Electronics GM862-QUAD-PY User Manual
Page 371
AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 371 of 434
#EMAILACT - E-mail GPRS Context Ativation
SELINT 2
context #1 raises an error.
Note: if the PDP context #1 has been activated issuing AT#EMAILACT=1,
then
• if you request to deactivate the PDP context #1 issuing AT#GPRS=0
DTE receives the final result code OK but nothing really happens
• if you request to deactivate the PDP context #1 during a call issuing
AT#EMAILACT=0 and then, after the call termination, you want to
activate the PDP context #1 again through #EMAILACT, you need to
issue the following sequence of three commands
AT#EMAILACT=1
OK
AT#EMAILACT=0
OK
AT#EMAILACT=1
OK
(Analogous considerations if you want to request the activation of PDP
context #1 issuing AT#GPRS=1, see #GPRS)
Note: this command is not allowed if GSM context is active (see
AT#SGACT=0,1).
AT#EMAILACT?
Read command reports the current status of the GPRS context for the e-
mail, in the format:
#EMAILACT:
where:
1 - GPRS context activated
AT#EMAILACT=?
Test command returns the allowed values for parameter
Example
AT#EMAILACT=1
OK
Now GPRS Context has been activated
AT# EMAILACT=0
OK
Now GPRS context has been deactivated.
Note
It is strongly recommended to use the same command (e.g. #EMAILACT)
to activate the context, deactivate it and interrogate about its status.
3.5.7.6.7 E-mail Sending - #EMAILD