Rainbow Electronics GM862-QUAD-PY - Manual (Page 222)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 222 of 434
+CMGS - Send Message SELINT 2
Note: it is possible to send a concatenation of at most 10 SMs; the
maximum number of chars depends on the : 1520 chars if GSM
03.38 default alphabet is used, 1330 chars if 8-bit is used, 660 chars if
UCS2 is used. If entered text is longer than this maximum value an
error is raised
AT+CMGS=? Test command resturns the OK result code.
Note To avoid malfunctions is suggested to wait for the +CMGS: or
+CMS ERROR: response before issuing further commands.
Reference GSM 07.05
3.5.5.4.2 Send Message From Storage - +CMSS
+CMSS - Send Message From Storage SELINT 0 / 1
AT+CMSS=
[,
[,]] Execution command sends to the network a message which is already
stored in the storage (see +CPMS) at the location .
Parameters:
- location value in the message storage of the message
to send
- destination address, string type represented in the currently selected
character set (see +CSCS); if it is given it shall be used instead of the
one stored with the message.
- type of destination address
129 - number in national format
145 - number in international format (contains the "+")
If message is successfully sent to the network then the result is sent in the
format:
+CMSS:
where:
- message reference number.
If message sending fails for some reason, an error code is reported:
+CMS ERROR:
Note: to store a message in the storage see command +CMGW.
Note: care must be taken to ensure that during the command execution,
which may take several seconds, no other SIM interacting commands are
issued.
Note To avoid malfunctions is suggested to wait for the +CMSS: or +CMS
ERROR: response before issuing further commands.
Reference GSM 07.05