Rainbow Electronics GM862-QUAD-PY - Manual (Page 414)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 414 of 434
#STARTMODESCR - Script Execution Start Mode SELINT 2
parameter active script will not be executed (default is 10).
AT#STARTMODESCR? Read command reports the current script start mode and the current
script start time-out, in the format:
#STARTMODESCR= ,
AT#STARTMODESCR=? Test command returns the range of available values for parameters
and , in the format:
#STARTMODESCR: (0,2),(10-60)
3.5.7.10.4 Execute Active Script - #EXECSCR
#EXECSCR - Execute Active Script SELINT 0 / 1
AT#EXECSCR Execution command causes the current script (see #ESCRIPT) execution
not at startup.
This command is useful when the execution at startup has been blocked
deliberately and the user wants to control execution start.
AT#EXECSCR? Read command has the same behaviour as execution command
AT#EXECSCR=? Test command returns OK result code.
#EXECSCR - Execute Active Script
SELINT 2
AT#EXECSCR Execution command causes the current script (see #ESCRIPT) execution
not at startup.
This command is useful when the execution at startup has been blocked
deliberately and the user wants to control execution start.
AT#EXECSCR=? Test command returns OK result code.
3.5.7.10.5 Read Script - #RSCRIPT
#RSCRIPT - Read Script SELINT 0 / 1
AT#RSCRIPT=
Execution command reports the content of file .
Parameter:
- file name, string type (max 16 chars, case sensitive).
The device shall prompt a three character sequence
(IRA 60, 60, 60)
followed by the file content.
Note: if the file was saved with the hidden attribute, then an
empty file is reported with the OK result code.
Note: If the file is not present an error code is reported.
Example AT#RSCRIPT="First.py "
hereafter receive the prompt: depending on your editor