Rainbow Electronics GM862-QUAD-PY - Manual (Page 175)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 175 of 434
+CSCA - Service Center Address SELINT 0 / 1
PDU mode, setting is used by the same commands, but only when the
length of the SMSC address coded into the parameter equals zero.
Note: the current settings are stored through +CSAS
Note: issuing AT+CSCA is the same as issuing the Read command.
Note: issuing AT+CSCA= causes an OK result code to be issued.
AT+CSCA? Read command reports the current value of the SCA in the format:
+CSCA: ,
Note: if SCA is not present the device reports an error message.
AT+ CSCA=? Test command returns the OK result code.
Reference GSM 07.05
+CSCA -Service Center Address
SELINT 2
AT+CSCA=
[,] Set command sets the Service Center Address to be used for mobile
originated SMS transmissions.
Parameter:
- SC phone number in the format defined by
- the type of number
129 - national numbering scheme
145 - international numbering scheme (contains the character "+")
Note: to use the SM service, is mandatory to set a Service Center Address
at which service requests will be directed.
Note: in Text mode, this setting is used by send and write commands; in
PDU mode, setting is used by the same commands, but only when the
length of the SMSC address coded into the parameter equals zero.
Note: the current settings are stored through +CSAS
AT+CSCA? Read command reports the current value of the SCA in the format:
+CSCA: ,
Note: if SCA is not present the device reports an error message.
AT+CSCA=? Test command returns the OK result code.
Reference GSM 07.05
3.5.5.2.2 Set Text Mode Parameters - +CSMP
+CSMP - Set Text Mode Parameters SELINT 0 / 1
AT+CSMP[= Set command is used to select values for additional parameters for storing